Hi, I want to share 2 setups for the 9x Radio + HT8 module.
The first one it’s the default setup.
Mellow setup it’s for those who are just started and want to flow the heli with no negative pitch (it’s similar to a 4Ch heli)
Just upload them into your 9x radio and make changes if you want.
FBL100 / V922 HT8 https://www.box.com/s/qhz1eztyt1or6g2s39fc
The V911 it’s a bit lazy flying forward…. A good idea to improve the fast forward flight involves changing the CG putting the battery more closer to the nose, but if you don’t want to modify the CG you can try my new mix. The idea it’s to put more thrust on the main rotor when you push the elevator stick. With the stock program when you push the elevator stick the main blades go down a few rpm so the heli goes forward and lose some altitude, with my program you will compensate that effect.
The program has been made with Eepe and runs on Er9x and it has not been tested on Open9x
Here it’s the Mix section:
CH03 +125%THR Switch(ID0) Curve(c1)
R +125%THR Switch(!ID0) Curve(c2)
R -100%HALF Switch(THR)
CH05 R +50%P1 Offset(100%)
CH06 R +50%P3 Offset(100%)
As you can see above the ELE switch puts a 6% more thrust when activated and the GEA puts 10%. You can try it and adjust yourself to your needs, the trick it’s to maintain the forward flight without making the heli going up due the increase of thrust. Try different values and find the perfect one. If you increase the value a lot the heli goes up quickly so try to use 1% increments when trimming.
Try and comment 🙂